Français Contact Us Help Search Canada Site
Home
About CSA
Image Gallery
Careers
Resources
 Audiences
 .Media
 .KidSpace
 .Educators
 .Industry
 .Scientific community
 Activities
 .Earth Observation
 .Satellites
 .Science
 .Exploration
 Bulletin
 .APOGEE
John H.
Chapman
Space Centre
David
Florida
Laboratory
 .Virtual Visit
  Index A to Z
You are here: home | satellites | radarsat2 | deployment animation
RADARSAT-2 Deployment Animation


Click on the image to start the animation
(AVI Clip - 2.78 MB)

© This animation was produced and provided by MacDonald, Dettwiler and Associates Ltd.

Step-by-step Description

1- RADARSAT-2 release from Launch Vehicle
RADARSAT-2 will be launched on a Boeing Delta-2 launch vehicle and will be placed in a sun-synchronous orbit at an altitude of approximately 800 km.

2- Stabilisation:
This stage will start automatically upon detection of the spacecraft separation from the launch vehicle. Spacecraft initialisation consists of switching on sensors: GPS, Magnetometer, Gyro and Sun Sensor. At launcher release, the spacecraft will autonomously recognise its angular rate, damp it and acquire controlled attitude. Upon success of de-spin and first sun acquisition, RADARSAT-2 will start to acquire a coarse stable 3-axes attitude. This process should take 2-3 orbits.

3- Solar Arrays deployment
Following the stabilisation of the spacecraft, the Solar Arrays will be deployed by ground command. The Solar Arrays can be deployed one at a time or simultaneously. The deployment will not exceed 2 minutes for each wing.

4- Antenna tie-downs release and SAR antenna deployment
The antenna tie-downs will be released automatically or by ground command. The Synthetic Aperture Radar (SAR) antenna will then be deployed by ground command. The SAR wings can be released one at a time or simultaneously and the deployment should not exceed 5 minutes for each wing.

Deployment State is completed at this point and RADARSAT-2 is ready to move in Mission State.

5- Imaging state
RADARSAT-2 will be able to switch from right- to left-looking mode. This process will take about 10 minutes. About 75% of imaging will be performed in right-looking: the left-looking mode will be used for Antarctic mapping, emergency situations and to improve market access.

Several imaging modes are available with RADARSAT-2 (incidence angles, resolution and polarization). A single image take may vary from a minimum of 5 seconds to a maximum of 28 minutes.

Updated: 2003/06/17 Important Notices