• How old is the furnace?
• When was the last maintenance service done?

• Repair or replace old equipment. Every piece of equipment has a natural life span even if it’s maintained correctly.
• Maintain equipment regularly so that it operates safely and efficiently.

• Old furnace motors are not as efficient as newer models. Hot water-based heating systems may have inefficient boilers and pumps.
• Inadequate maintenance shortens equipment life span and can lead to premature failure, incomplete fuel combustion and backdrafting of combustion gases. Clogged filters are a fire hazard. Cracked heat exchangers allow combustion gases into the home’s air.

• Is the heating system making too much noise?

• Have your HVAC system assessed by a professional HVAC contractor. Noise in a forced warm air heating system may be the result of fans and blowers that are not maintained or properly attached to the house structure. Noise can also be created because of undersized ducts.
• In water based (hydronic) heating systems, noise may be generated as pipes expand and contract when the system heats up and cools down. Some noise may be the result of improperly attached pipes that do not allow for thermal expansion and contraction. The water in the system could also be too hot.

• Noisy heating system components, particularly fans and pumps, can suggest that they are near the end of their useful life and could fail at any time.

• Is there a wood smoke smell from the fireplace in the house? Are there combustion smells?

• Investigate the source of the smells and take action to correct the problem. Regularly noticing smells from combustion gases and wood smoke from the fireplace or other combustion appliances in the house suggests that the flue is not functioning properly. It may also be the result of pressure imbalances in the house that can be solved by flue maintenance, properly balancing the heating system and adding make-up air.

• Combustion by-products are toxic and in the worst cases can cause death.

• Does smoke come into the house from the chimney? Are there fuel smells in the furnace area?

• Get the chimney inspected and cleaned by a qualified tradesperson.

• Blocked and dirty flues are a fire hazard. If flues are blocked entirely, then combustion gases will spill into the house, which can have serious health impacts and can cause death.

• Are there any fuel-burning appliances in the house? Are there any smoke or gas detectors?

• Install a smoke detector and a carbon monoxide (CO) detector to alert you to any combustion gas spillage that may be occurring.

• Combustion gas spillage is a major safety risk that can have serious health impacts at high concentrations. Carbon monoxide is toxic and can cause death.

• Is there even distribution of heat throughout the house? Are there cold spots?

• Make sure the warm air registers (or hot water valves in a hydronic system) are open to allow heat in.
• Upgrade the insulation in cold areas. Cold spots can be caused by an improperly laid out or inadequate heating system.
• Balance the heating system and seal the ducts. This will likely be needed when major renovations are being done and if the heating ducts (or hot water pipes) are exposed.
• Consider using supplementary heaters or booster fans to provide additional heat. This could be an electric heater or electric radiant panels in the floor.

• Cold spots in the house, especially on outside walls and ceilings, are areas where condensation will occur. Condensation, dust and other organic material on the wall surface creates ideal conditions for mold growth that can compromise indoor air quality (IAQ) in the house.
• Improper or inadequate adjustment of the heating system can create excessive pressure imbalances in the room. This could affect the operation of combustion appliances in the house.
• Adjustments after a renovation may require changes to the finished work.

• Are there heating ducts or pipes that run through unheated space such as an unheated crawl space or in the attic area?

• Air-seal and insulate the ducts or water pipes to reduce heat loss in unheated spaces. Consider relocating the ducts.

• Heat will continue to be lost through uninsulated ducts or pipes. Condensation can form in the ducts, which can cause moisture problems and be a breeding ground for mold. Ducts can also carry dust, mold spores and other contaminants that can be drawn into the house.

• Are there areas of the house that always seem drafty and uncomfortable?

• Air-seal the house including repairing or replacing window and door weatherstripping. Areas that are constantly drafty suggest large amounts of air leakage.

• Outdoor air will continue to enter, carrying in pollens and dust from the outside.
• Warm air carrying moisture can escape through cracks and pores of the building causing moisture problems indoors.

• Is it difficult to maintain comfort conditions?

• Replace old controls. Maintaining constant temperatures requires good controls. Place thermostat in a location that is out of the sun to get an accurate reading of the average house temperature.
• Consider zoning the house, so that the sunny south side would be on its own zone, while areas in constant shade or on the north side would have their own control.

• Comfort conditions will be hard to maintain. Older thermostats are not as accurate as today’s electronic models. Electric heaters with built-in thermostats are especially vulnerable to wide temperature swings as the heating element itself influences the thermostat.
• Improperly placed thermostats that are too close to a heating element, an outside door or in direct sunlight will not be able to provide a proper control function.

• Does there seem to be stale air in the house? Do smells linger?
• Is the house too humid?

• Install a heat recovery ventilator that can operate continuously, at low speed. Exhaust-only ventilation systems do not provide a balanced flow (like heat recovery ventilators) and can result in lower air pressures in the house, compared to the outside. This can cause combustion appliances to backdraft.
• Choose a quiet, good quality fan for the main bathroom with a timer switch that can be set to operate at least eight hours in every 24, either in one period, or in several periods spread over the day and night. Make sure that the kitchen range hood fan exhausts to the exterior.

• Inadequate air change rates in the house create poor indoor air quality conditions that can compromise health over time.
• Excessive humidity build-up can deteriorate finishes, the structure and contribute to mold growth.

• Is the house very dusty?

• Air-seal and draftproof the house. High dust levels in the house are a sign of excessive air leakage from outside.
• Vacuum frequently to remove dust.
• Add a medium efficiency pleated filter or electronic filter to the forced air heating system. The filter will capture a lot of the dust within the house. However, the fan must be adequately sized and set to operate continuously to move air past the filter.

• The house will continue to be drafty and dusty.
• If the fan does not operate continuously, the filter will not do anything. Continuous operation of an improperly sized fan with an inefficient motor can increase electrical power consumption.

• Is the house too humid or too dry at various times of the year?

• Repair, replace or install a new mechanical ventilation system. High humidity in the winter is usually an indicator of very low air exchange in a well air-sealed house. Some houses may have high humidity in the summer. This may be a result of local climate conditions (hot, humid, summer weather in central Canada).
• Install a dehumidifier, especially if the house is not air-conditioned. An air-conditioning system should help dehumidify the air. Too low a humidity level in the winter is an indicator of excessive air change rates. Air sealing the house will reduce the uncontrolled air change.

• High humidity creates unhealthy conditions. Molds, fungi and mites thrive in warm, damp environments.
• Excessively dry conditions dry our mucous membranes, lowering our resistance to bacteria.

• Is there any renovation work planned that will require changes in the HVAC equipment or ducts throughout the house?
• Will a new addition exceed the demand of the current HVAC equipment?

• Assess how extensive the changes will need to be to the HVAC system. If significant changes are planned or your system is close to the end of its life span, it may be cost effective to install new, more efficient equipment. Remember that the house is a system. New windows or air sealing may reduce the demand of HVAC or create the need for controlled make-up or combustion air.
• Upgrade or replace the HVAC equipment to meet new demands.

• New equipment may need to be installed in the near future that could cause added disruption.
• Undersized or inadequate equipment will not provide the comfort and service that you expect.

Rewards

• A properly operating HVAC system not only maintains comfortable indoor conditions, but also ensures a healthier home environment for you and your family.
• Your new mechanical systems will have lower operating costs, increased safety and give you peace of mind.

Skills to Do the Job

Basic mechanical systems maintenance, including filter replacement and motor oiling as identified in manufacturers’ manuals, is a job you can do. However, qualified HVAC contractors must do any adjustments or equipment upgrades that are needed.

Your local energy utilities and heating industry associations can give you information and refer you to competent tradespeople. Heating systems distributors in your area can also give you references to the local associations and tradespeople.