Standards Relating to Design, Construction and Operational Safety of Dynamically Supported Craft in Canada Vol. 1; Air Cushion Vehicles | TP 5579

Français

Help

Canada Site

Home	About us	Media room	Environment	Emergencies
Air	Marine	Rail	Road	Major issues

•	Table of Contents
•	Application
•	Definitions
•	General Standards relating to the Design, Construction and Operational Safety Certification of Air Cushion Vehicles (A.C.V's) in Canada.
•	Chapter 2 - Design - General.
•	Chapter 3 - Buoyancy, Sub-Division and Hydrostatic Stability.
•	Chapter 4 - Dynamic Stability and Control.
•	Chapter 5 - Structural Strength
•	Chapter 6 - Materials
•	Chapter 7 - Main Machinery
•	Chapter 8 - Auxiliary Power Units
•	Chapter 9 - Fluid Systems
•	Chapter 10 - Fire Safety
•	Chapter 11 - Compartment Design
•	Chapter 12 - Control Stations, Monitoring and Alarms
•	Chapter 13 - Electrical Systems
•	Chapter 14 - Navigation and Communication Equipment
•	Chapter 15 - Marine Equipment
•	Chapter 16 - Life-Saving Equipment
•	Division 2 - Operational Equipment
•	Division 3 - Construction & Installation
•	Division 4. Functional Tests and Trials
•	Division 5. Vehicle Technical Information
•	Division 6 - Vehicle Certification Documentation
•	PDF version

•	Marine Safety Publications
•	Marine Safety Home Page

Transport Canada > Marine Safety Home Page > Transport Publications | Marine Safety > Standards Relating to Design, Construction and Operational Safety of Dynamically Supported Craft in Canada Vol. 1; Air Cushion Vehicles | TP 5579 | Marine Safety

PREVIOUS | TABLE OF CONTENTS | NEXT

Division 2 - Operational Equipment

2100. Any equipment intended for installation and use in an A.C.V., additional to that required by Division 1 of these Standards shall be designed and installed in compliance with the applicable section(s) of these Standards.

2101. The design and installation of operational equipment required by these Standards, but which may be subject to optional choices of installation or equipment shall in all cases comply with the relevant section(s) of these Standards.

2102. Where applicable and necessary for the demonstration of compliance with operational safety provisions, the vehicle designer shall carry out such additional tests of the installed equipment as may be required, to an approved schedule.

PREVIOUS | TABLE OF CONTENTS | NEXT