![]() |
|||||||||||||
![]() |
|||||||||||||
|
|||||||||||||
![]() |
![]() ![]() |
Keeping safe through adapting your homeIf you're thinking of renovating, why not consider adding a few additional safety features to your home to help make it a comfortable and safer place for years to come? Should you decide to move, the increased safety and accessibility could also be selling features. Word of mouth is often the best way to find reliable tradespeople to do renovations. Ask friends and acquaintances for information, and be sure to get price quotes from at least two potential contractors. The following suggestions will give you some ideas for your renovation planning. Lighting and switches It's important to have plenty of well-positioned and well-diffused lighting. If you're having electrical work done, consider adding lighting in high traffic areas, in stairways, in closets and over the bathroom sink and kitchen work areas. Install switches at the top and bottom of your stairs. Consider installing all switches lower on the walls if someone in your household uses a wheelchair. Rocker switches are easier to use. Dimmer switches allow you to leave certain lights on low, for example, between the bedroom and bathroom. Electrical outlets Adding more electrical outlets will help prevent overloading or having to run electrical cords across areas where they may be in the way. Extension cords should never be used on a permanent basis, since this presents a fire hazard. Power bars can help prevent short circuits and fires. Doors If you plan to work on or replace a door, check the height of the door sill or threshold. It should be no more than 1/2" (13 mm) high. It may be a good idea to reduce or remove the door sill because uneven surfaces can lead to a trip or a fall. You may also want to widen doorways to accommodate wheelchairs or replace doorknobs with lever handles, which are easier to use. Also, consider the advantages of sliding or swinging doors, and doors that open outward. Stairs The backs of stairs should be closed in. There should be firmly anchored handrails on both sides of the stairway (height 36 to 39 inches), which extend beyond the top and bottom steps and are mounted far enough out from the wall to allow for a solid grip. In addition, the stairway should be well lit and the steps should have a non-skid surface. Flooring If you're replacing flooring, use non-glare, slip-resistant flooring material. A hard floor surface or tight pile carpeting is best. Consider using the same floor surface over different areas in order to eliminate uneven surfaces. Shelving For efficiency and convenience in your kitchen, consider adding lower level shelves, such as between the counter top and cupboard level. Lower cupboards, sliding shelves and lazy-susans in cupboard corners put kitchen items within easier reach. Taps, shower heads, grab bars If you plan to replace your kitchen or bathroom taps, lever-type or control-arm-type faucet handles are easier to use. Make sure you install grab bars solidly on the wall studs. A hand-held shower head is easier to use when using a bath seat. Locks and latches Door locks in bathrooms must have an emergency release. Locks and latches should have large, easily manipulated knobs or levers. The market now has models that offer both safety and security, such as push-button or card-access locks. Workroom Windows and overhead lights are a must. Additional lighting should also be available over benches and stationary tools. Adequate ventilation systems are needed to vent smoke, fumes and exhaust gases. Open windows and doors may provide enough ventilation in the summer but not in the winter. The wiring must be of adequate capacity to handle lighting, heating and power tool requirements. ![]()
[Previous] [Table of Contents] [Next] |
|